-
1.The manufacturer's specifications require a cladding surface diameter deviation of no more than 0.025 mm.
制造商的规格要求镀层表面直径偏差不超过0.025毫米。
-
2. The engineer used this tool to measure the deviation of the cladding surface diameter.
工程师使用这个工具来测量镀层表面直径的偏差。
-
3. Due to the manufacturing process, there may be some deviation in the cladding surface diameter.
由于制造过程，镀层表面直径可能会有一些偏差。